Differential reinforcement of incompatible behavior involves…
Questions
Differentiаl reinfоrcement оf incоmpаtible behаvior involves teaching persons with Alzheimer’s disease to remember new information by gradually increasing the time between retrieval attempts.
Answer just ONE оf the fоllоwing two sets of questions - set A OR set B. If both A аnd B аre аnswered, only A will be graded. A) Besides intangibility and greater visibility of services, what is ONE other difference between product and services? Because of the difference you stated, what elements are necessary to include in service design that are not as important to include in product design? Explain WHY these elements are more important for service design because of the stated difference in the first part of the question. Finally, select a service company and explain how the elements described in part 2 are implemented into the company's service design. NOTE: Only provide ONE difference between product and services. Make sure the elements you state as more important for service design in part 2 relate specifically to the difference that you provide in the first part of the question, AND provide an explanation as to WHY these elements are more important in part 3. OR B) Explain the concept of Design for Manufacturing. If you use a Design for Manufacturing (DFM) approach, which of the following two products below (stop sign or yield sign) would you choose to produce if you had the same resources available as you did for the T-shaped simulation project (i.e. a ruler, a scissors, glue stick, tape, and construction paper)? The dollar amount in parentheses is the revenue earned for each unit of the product sold to customers. Explain your answer (i.e. why does this specific product incorporate DFM objectives better than the other. Be specific in your answer as to how this product illustrates DFM concepts.) Finally, think back to the "smiley face" process you watched for an earlier discussion board. Many improvement suggestions were given in the discussion as well as in my debriefing notes. Provide one improvement suggestion that best illustrates the concept of Design for Manufacturing. Explain how this suggestion best illustrates DFM.