Category: Uncategorized

Where are Spline Handles found on a spline?

What is the minimum number of guide curves required to create a Loft?

What view feature should be used for a drawing view that is too large to fit on the sheet, like the one shown below?  

A basic Sweep feature requires a ____________.

What is the minimum number of sketches needed to create the loft shown in the image?

Which sketch tool was used to create the curve shown in the image?

The dimensions applied to the broken view shows the true length of the part, even after breaking the view.

Which of the following would be selected to create the annotation of the hole shown in the drawing?  

The base diameter of a helix is defined:

The Loft Feature allows you to change the cross-sectional shape of the solid.