The system creates an On-Edge relation to all converted entities.
Blog
Which is a command/feature that converts a 2D drawing to a 3…
Which is a command/feature that converts a 2D drawing to a 3D model?
A proper profile for use in a revolved feature is a single c…
A proper profile for use in a revolved feature is a single closed contour created on one side of the revolved centerline.
You have to use the sketch tool to start drawing in 2D.
You have to use the sketch tool to start drawing in 2D.
An Equal relation makes the entities equal in size.
An Equal relation makes the entities equal in size.
You can define a sketch my adding smart dimensions from the…
You can define a sketch my adding smart dimensions from the origin
Which is not a hole wizard hole type
Which is not a hole wizard hole type
The current status of a sketch is displayed in the lower rig…
The current status of a sketch is displayed in the lower right area of the screen as: Under Defined, Fully Defined, or Over Defined
A center of a line is called a ______
A center of a line is called a ______
When the UP TO SURFACE option is selected, you have to choos…
When the UP TO SURFACE option is selected, you have to choose a surface as an end condition to extrude up to.