Blog

Which mode configuration setting would allow formation of an…

Which mode configuration setting would allow formation of an EtherChannel link between switches SW1 and SW2 without sending negotiation traffic?

Refer to the exhibit. A network administrator is configuring…

Refer to the exhibit. A network administrator is configuring an EtherChannel link between two switches, SW1 and SW2. Which statement describes the effect after the commands are issued on SW1 and SW2? 1(7).png

A high school uses VLAN15 for the laboratory network and VLA…

A high school uses VLAN15 for the laboratory network and VLAN30 for the faculty network. What is required to enable communication between these two VLANs while using the router-on-a-stick approach?

Which command will allow a network administrator to check th…

Which command will allow a network administrator to check the IP address that is assigned to a particular MAC address?

Refer to the exhibit. A network administrator is verifying t…

Refer to the exhibit. A network administrator is verifying the configuration of inter-VLAN routing. Users complain that PCs on different VLANs cannot communicate. Based on the output, what are two configuration errors on switch interface Gi1/1? (Choose two.) 3.png

Refer to the exhibit. A router-on-a-stick configuration was…

Refer to the exhibit. A router-on-a-stick configuration was implemented for VLANs 15, 30, and 45, according to the show running-config command output. PCs on VLAN 45 that are using the 172.16.45.0 /24 network are having trouble connecting to PCs on VLAN 30 in the 172.16.30.0 /24 network. Which error is most likely causing this problem? 1(1).png

Refer to the exhibit. A network administrator has configured…

Refer to the exhibit. A network administrator has configured router CiscoVille with the above commands to provide inter-VLAN routing. What type of port will be required on a switch that is connected to Gi0/0 on router CiscoVille to allow inter-VLAN routing? 5.png