Blog

The notched bar is subjected to an axial tensile load of P = 30 kN. The major bar width is D = 296 mm, the minor bar width at the notches is d = 288 mm, and the radius of each notch is r = 4 mm. If the maximum tensile stress in the bar must not exceed 78 MPa, determine the minimum required bar thickness using Neuber’s nomograph (Table 14.3 and Figure 14.10).

The beam has a rectangular cross section with D = 50 mm, d = 40 mm, r = 24 mm, and a thickness of 8 mm. If M = 19.6 N·m, determine the maximum normal stress at the section through the base of the fillets using Figures 14.24 and 25.

For the flat bar in Figure A of Table 14.3, let t = 1ρ and b = 25ρ. Using Neuber’s nomograph (Figure 14.10), determine the value of Scc for the case where the bar is subjected to axial tensile load.

(True or False) Tolerance and sensitization cannot occur simultaneously for the same drug.

Which of the following best describes tolerance?

For the flat bar in Figure A of Table 14.3, let t = 9ρ and b = 36ρ. Using Neuber’s nomograph (Figure 14.10), determine the value of Scc for the case where the bar is subjected to axial tensile load.

What percentage of individuals become dependent on nicotine after using it?

Consider a circular hole in a plate with stresses σx = 23 MPa and σy = 85 MPa applied to the plate edges. Determine the maximum tensile stress in the plate.

For the flat bar in Figure A of Table 14.3, let t = 4ρ and b = 36ρ. Using Neuber’s nomograph (Figure 14.10), determine the value of Scc for the case where the bar is subjected to axial tensile load.

Methadone and buprenorphine are considered treatments for opioid use disorders.