Calculate [45.3 – 25.2]. You may use your calculator.
Blog
A beam is part of the framing system for the floor of an off…
A beam is part of the framing system for the floor of an office building. The floor is subjected to both dead loads and live loads. The maximum moment caused by the service dead load is 44 ft-kips, and the maximum moment for the service live load is 48 ft-kips (these moments occur at the same location on the beam and can therefore be combined). If ASD is used, what is the required nominal strength of the beam for a safety factor Ω of 1.50?
Which manufacturing process produces the largest category of…
Which manufacturing process produces the largest category of standard cross-sectional shapes?
A tension member must be designed for a service dead load of…
A tension member must be designed for a service dead load of 49 kips and a service live load of 5 kips. If LRFD is used, determine the maximum factored load (required strength), Ru.
Describe any of the following endocrine glands’ one hormones…
Describe any of the following endocrine glands’ one hormones. Include the following information.The name of the hormone, abbreviation is fine. (.5 points)Function of the hormone. (.5 points)Name the disease caused due to hypo and hypersecretion. (1 point)A. Adrenal glandB. Pituitary glandC. Thyroid glandD. Pancreas
When calculating the net area of a bolted connection, how mu…
When calculating the net area of a bolted connection, how much should be added to the hole diameter to account for the damage caused by punching the bolt holes?
A 0.73 in. x 5.6 in. plate is connected to a gusset with fou…
A 0.73 in. x 5.6 in. plate is connected to a gusset with four 1-1/2 in. bolts. Standard sizing is used for the bolt holes. What is the gross area of the plate?
A flat roof is subject to the following uniformly distribute…
A flat roof is subject to the following uniformly distributed loads: a dead load of 30 psf (pounds per square foot of roof surface), a roof live load of 15 psf, a snow load of 17 psf, and a wind load of 17 psf downward. If ASD is used, what is the required nominal strength of the member for a safety factor Ω of 1.25?
A flat roof is subject to the following uniformly distribute…
A flat roof is subject to the following uniformly distributed loads: a dead load of 32 psf (pounds per square foot of roof surface), a roof live load of 13 psf, a snow load of 12 psf, and a wind load of 17 psf downward. If ASD is used, what is the required nominal strength of the member for a safety factor Ω of 1.45?
Building codes are legal documents containing safety require…
Building codes are legal documents containing safety requirements. ASCE 7 Minimum Design Loads for Buildings and Other Structures is a building code.