Blog

Problem 4) 4:1 MUX Write a System Verilog module named MUX41…

Problem 4) 4:1 MUX Write a System Verilog module named MUX41 with a procedural code, using a case statement to implement the figure below. The case statement should select on variable S. Use a default of n bit x (undefined) for F, and an initial value of n bit 0 (these must be done with replication). (Remember initialization is not done with the Verilog keyword initial, initial is only used in test benches and is not synthesizable.)  Parameterize inputs and outputs using the variable n, but you can assume S is 2 bits. The default for n should be 8. Your module should have n bit inputs A, B, C, D,  two bit select S, and n bit output F. F is determined by: Select 0 should be A, 1 should be B, 2 should be C, 3 should be D. The design should be to create parallel logic. Serial logic is not acceptable. For maximum credit your code should carefully follow the specification. Use the minimum number of lines to accomplish this specification, your code should be succinct and well organized. Also use proper indentation for organization. (If you instantiate a MUX to accomplish this you have to write the code for the MUX using a case so that you show you understand how to do that) Use System Verilog, always_ff, and always_comb, and don’t use reg datatype. (hint: see cheat sheet) Declare all variables, avoid errors or warnings that would occur during compilation, simulation or synthesis. Indent all blocks for full credit. Your code should be efficient and succinct. Don’t use compiler directives or short cuts.