After seeing a patient with c-diff, which of the following is the most appropriate method for cleaning equipment.
Blog
An individual who recently experienced a myocardial infarcti…
An individual who recently experienced a myocardial infarction has been evaluated by the OT and is currently receiving occupational therapy intervention. A primary concern of the cardiac team is to prevent “overexertion” in therapy. What is the BEST way to address this concern?
Autonomic Dysreflexia is considered an abnormal response to…
Autonomic Dysreflexia is considered an abnormal response to a noxious stimulus that results in an extreme rise in blood pressure, pounding headache, and profuse sweating that is deemed a medical emergency. What is the appropriate immediate action that must be taken to address this condition?
You are working with a patient in the hospital who has COPD….
You are working with a patient in the hospital who has COPD. You notice that he is demonstrating SOB upon arriving to his room, therefore, you take his vital signs. His oxygen saturation reads 88% and his respiration rate is 22 breaths per min. Which of the following is a normal respiration rate and oxygen saturation?
In the early 1900s, occupational therapy focused on handicr…
In the early 1900s, occupational therapy focused on handicrafts and work activities. Which of the following is not considered a handicraft or work activity?
A rocket, initially at rest, is fired vertically with…
A rocket, initially at rest, is fired vertically with an upward acceleration of 11 m/s2. At an altitude of 500 meters, the engine of the rocket cuts off. What maximum height above the ground does the rocket achieve?
A box has the dimensions shown. What is its volume in cubi…
A box has the dimensions shown. What is its volume in cubic centimeters (cm3)? (Select closest answer. Note: 1 inch = 2.54 cm)
The grey figure above is a uniform sheet. Find the location…
The grey figure above is a uniform sheet. Find the location of its center of mass.
A 3 kg block is dragged over a displacement of 2 meters by a…
A 3 kg block is dragged over a displacement of 2 meters by a constant force P acting at an angle of 37o above the horizontal as shown. The surface is rough, and a constant frictional force f opposes the motion. What work was done by the frictional force f during this displacement?
Extra Credit for 5 pts): A light spring is placed betwee…
Extra Credit for 5 pts): A light spring is placed between blocks of masses m1 and m2 on a frictionless surface, as shown. The blocks are pushed together, compressing the spring a distance of 15 cm, and held there. The blocks are then released from rest. After the blocks lose contact with the spring ends, m1 has a speed of 3 m/s. What is the force constant, k, of the spring? Show and explain all work!