If an aircraft is not equipped with an electrical or anticollision light system, no person may operate that aircraft
Blog
To act as pilot in command of an airplane towing a glider, t…
To act as pilot in command of an airplane towing a glider, the tow pilot is required to have
(Refer to Figure 38.)|GIVEN: Empty weight (oil is included)…
(Refer to Figure 38.)|GIVEN: Empty weight (oil is included) 1,271 lb, Empty weight moment (in-lb/1,000) 102.04, Pilot and copilot 360 lb, Cargo 340 lb. Fuel 37 gal, Will the CG remain within limits after 30 gallons of fuel have been used in flight?
(Refer to Figure 9.) Using a normal climb, how much fuel wou…
(Refer to Figure 9.) Using a normal climb, how much fuel would be used from engine start to 12,000 feet pressure altitude. Aircraft weight 3,800 lb. Airport pressure altitude 4,000 ft. Temperature 26__degrees__C
Which is true concerning required maintenance inspections?
Which is true concerning required maintenance inspections?
While taxiing for takeoff, a small fire burned the insulatio…
While taxiing for takeoff, a small fire burned the insulation from a transceiver wire. What action would be required to comply with NTSB Part 830?
The maximum cumulative time that an emergency locator transm…
The maximum cumulative time that an emergency locator transmitter may be operated before the rechargeable battery must be recharged is
(Refer to Figure 32.) Determine the approximate runway lengt…
(Refer to Figure 32.) Determine the approximate runway length necessary for takeoff. Given: Temperature = 40 degrees F. Pressure altitude = 4,000 ft. Weight = 3,200 lbs Headwind = 15 kts
Pilots who change their permanent mailing address and fail t…
Pilots who change their permanent mailing address and fail to notify the FAA Airmen Certification Branch of this change, are entitled to exercise the privileges of their pilot certificate for a period of
Write a program, that asks for a radius and then will calcul…
Write a program, that asks for a radius and then will calculate the diameter, circumference, and area of a circle. Diameter = 2r Circumference = 2πr Area = πr2 Your program should loop until a zero value for the radius is entered.